Narrow Boat Hull Paint

narrow boat hull paint

The metal hull of a narrowboat is blacked to protect the bottom section of the boats hull. epoxy paint will last on its own 5 to 6 years once applied, bitumen finished coating will last around 2 to 3 years, however with the zinc and two pack epoxy up to 10 years.. By painting the outside of the shell, you prevent both of these from being able to reach the surface for 2-3 years, so regular re-painting is a necessity. in the case of the boats hull, it is important that you thoroughly coat it with "blacking" (often a bitumen or coal-tar based paint).. A fun subject and a fun task, narrowboat hull protection is necessary if we wish to protect our investment long term. the reasons behind the need to protect the narrow boat hull are simple, but the corrosion mechanisms themselves are complex. aside from galvanic corrosion, we talk a lot about the harsh day to day life of the narrow boat hull..

Burgess marine clear sealer

Narrowboat anti-slip painting | anti-slip painting of

narrow boat hull paint Springer narrowboat hulls were produced using thinner steel than newer boats ; with modern narrowboats nowadays usually built to a specification of 10/6/4mm (the first figure is the hull thickness ) although springers were built in a v shape to create a stronger structure.. Crashing through ice will damage the paint protecting the hull, as will crashing into banks and locks, so responsible cruising will lessen the chances of the hull being damaged. when the narrow boat is out of the water you can get the hull pressure washed to enable you to check the hull and stern gear..